SHIFTER AND MIDDLE GEAR
1. Remove:
• Crankcase cover (Left) 1
• Gasket
• Dowel pin 2
• Shift shaft 3
• Shift lever 4
• Oil level maintaining plug 5
2. Remove:
• Middle driven gear housing 1
• Shims 2
3. Remove:
• Bearing retainer 1 Use Torx Driver #40 (90890-04049).
CRANKCASE
1. Remove:
• Bolts (Crankcase)
• Clamps
• Battery negative lead
NOTE:
• Remove the bolts starting with the highest numbered one.
• The embossed numbers in the crankcase designate the crankcase tightening sequence.
Upper crankcase
Lower crankcase
2. Remove:
• Lower crankcase
• Blind plug (from crankcase right end)
• Crankshaft bearings
NOTE:
Identify each crankshaft bearing position very carefully so that it can be reinstalled in its original place.
- Printer-friendly version
- Log in to post comments