750XS (MaximX)

Steering Head

STEERING HEAD

Description

COOLANT FLOW

Specifications -- Engine fasteners torque settings

Part to be tightened

Part name

Gears, Starter Drive and Shift Drum

MAIN AXLE AND MIDDLE DRIVE GEAR

1. Remove:
• Middle drive gear 1
• Main axle 2
• Bearing 3
• Dowel pins 4
• O-ring 5

A.C.G. SHAFT, STARTER DRIVE, AND CRANKSHAFT

Cylinder Head

CYLINDER HEAD

 

1 Check bolt
2  Dowel pin
3 Camshaft case gasket
4 Valve guide

5 O-ring

6 Camshaft case
7 Cylinder head
8 Oil pipe
[A]
Be sure the "UP" mark faces upward.

Front Fork

FRONT FORK

Cable Routing

CABLE ROUTING (1)

 

 

General Information and Operation

CARBURETION

 

CARBURETOR

Rear Wheel and Brake

REAR WHEEL

General Torque Specifications

GENERAL TORQUE SPECIFICATIONS

This chart specifies torque for standard fasteners with standard l.S.O. pitch threads. Torque specifications for special components or assemblies are included in the applicable sections of this book. To avoid warpage, tighten multi-fastener assemblies in a criss-cross fashion, in progressive stages, until full torque is reached. Unless otherwise specified, torque specifications call for clean, dry threads. Components should be at room temperature.