700XSC (MaximX)

INSPECTION

1. Check
• teeth of middle gear for discoloration/Pitting/Wear. If necessary, replace all middle gears as a set.
• Damper cam surfaces for wear/Unsmooth action. Replace if necessary.

2. Check bearing movement. Rotate the race by finger and replace if rough. 

CYLINDER HEAD

1 Check bolt
2  Dowel pin
3 Camshaft case gasket
4 Valve guide
5 O-ring
6 Camshaft case
7 Cylinder head
8 Oil pipe
[A] Be sure the "UP" mark faces upward.

(1) Oil

FINAL GEAR OIL Oil Level Measurement

1.  Place the motorcycle on a level area and place on its centerstand.

2.  Remove the oil filler cap

3.  Observe the  oil level (2) and add oil if necessary.

MAIN AXLE AND MIDDLE DRIVE GEAR

1. Remove:
• Middle drive gear 1
• Main axle 2
• Bearing 3
• Dowel pins 4
• O-ring 5

A.C.G. SHAFT, STARTER DRIVE, AND CRANKSHAFT

COOLANT FLOW

STEERING HEAD

1. Measure fuel level. Adjust if out of specification.

Measurement steps:

• Place the motorcycle on a level surface.
• Shim the center stand as required to level from side to side using a level across the carb bank

LIGHTING SYSTEM

Chassis