650LK (Turbo)

General Torque Specifications and Conversion Tables

Submitted by xjcdadmin on Tue, 06/09/2009 - 12:50

General Torque Specification*

This chart specifies torque for standard fasteners with standard I.S.O. pitch threads. Torque specifications for special components or assemblies are included in the applicable sections of this book. To avoid warpage, tighten multi-fastener assemblies in a
criss-cross fashion, in progressive stages, until full torque is reached. Unless otherwise specified, torque specifications call for clean, dry threads Components should be at room temperature.

Switches and Relays

Submitted by xjcdadmin on Thu, 06/04/2009 - 22:38

EMERGENCY SHUT-OFF SWITCH

The emergency shutoff switch is a mechanical switch and mounted behind the headlight. This switch will shut off the ignition system if for any reason the motorcycle reaches a lean angle of 60 degrees or more from vertical.

Removal

1.    Remove the required fairing.

2.    Disconnect the lead wires from the wire harness and pull out the switch assembly from its rubber mounting harness.

Ignition Control System

Submitted by xjcdadmin on Thu, 06/04/2009 - 22:23

This motorcycle is equipped with the conventional transistor advance system as well as a semi conductor controlled boost sensor and a knock sensor. These combine to produce the optimum ignition timing according to engine conditions (i.e., engine speed, load, knocking, etc.).

Ignition system block diagram

VACUUM ADVANCE CONTROL SYSTEM

Subscribe to 650LK (Turbo)