650J (Maxim)

Clutch and Shifter Reassembly

Submitted by xjcdadmin on Mon, 05/10/2010 - 18:49

5. Clutch assembly

a. Install the thrust plate onto the transmission main axle.

1. Thrust plate

b. Install the oil pump drive sprocket onto the main axle without the spacer collar and place the oil pump drive chain on its sprocket.

1. Oil pump drive sprocket

Lower Crankcase Disassembly

Submitted by xjcdadmin on Mon, 05/10/2010 - 18:49

L. Lower Crankcase

1.    Remove the dowel pin and "O-ring".

2.    Remove the shift fork guide bar and shift forks. The shift forks are identified by numbers cast on their sides.

3.    Remove the bolt securing the shift cam locating pin and remove the stopper plate and locating pin.

4.    Remove the neutral switch.

Crankshaft, Con rods and Bearings -- Inspection and Repair

Submitted by xjcdadmin on Mon, 05/10/2010 - 18:49

I. Crankshaft

1. Crankshaft run-out

Support
the crankshaft at both ends on V-blocks. Measure the amount of
crankshaft run-out on the main bearing journals with a dial gauge while
rotating crankshaft.

Run-out limit: 0.040 mm (0.0016 in)

If run-out exceeds limit, replace crankshaft.

2. Inspection of bearings

Pistons and Cylinder Reassembly

Submitted by xjcdadmin on Mon, 05/10/2010 - 18:49

11. Pistons and Cylinder a. Install the pistons on the rods. The arrow on the piston must point to the front of the engine.

NOTE:
Before installing the piston pin clips, cover the crankcase with a clean rag so you will not accidentally drop the circlip into the crankcase.
Always install new piston pin circlips.

Cylinder Head and Valves -- Inspection & Repair

Submitted by xjcdadmin on Mon, 05/10/2010 - 18:49

INSPECTION AND REPAIR

A.   Cylinder Head Cover

Place head cover on a surface plate. There should be no warpage. Correct by re-surfacing as follows:

Place #400 or #600 grit wet sandpaper on surface plate and re-surface head cover using a figure-eight sanding pattern. Rotate head cover several times to avoid removing too much material from one side.

B.   Cylinder Head