Cylinder Head

Submitted by xjcdadmin on Mon, 06/14/2010 - 15:41

CYLINDER HEAD

 

1 Check bolt
2  Dowel pin
3 Camshaft case gasket
4 Valve guide

5 O-ring

6 Camshaft case
7 Cylinder head
8 Oil pipe
[A]
Be sure the "UP" mark faces upward.

1. Install:
• Dowel pins 1
• Cylinder head gasket (New)
• Cylinder head

NOTE:
• Be careful not to damage the cam chain guide during installation.
• Pass the cam chain through the cam chain cavity.

2. Tighten nuts in sequence as shown and torque the nut in two stages.

Cylinder Head: [10 mm ] 37 Nm (3.7 m-kg, 27 ft-lb)

3. Install the cam chain guide (Front) 1

NOTE:
The lower end of chain guide must rest in the cam chain guide slot in the crankcase.