Electrical Component Locations
ELECTRICAL COMPONENTS
- Read more about Electrical Component Locations
- Log in to post comments
ELECTRICAL COMPONENTS
11. Pistons and Cylinder a. Install the pistons on the rods. The arrow on the piston must point to the front of the engine.
NOTE:--------------------------------------------------------
Before installing the piston pin clips, cover
the crankcase with a clean rag so you will
not accidentally drop the circlip into the
crankcase.
SPECIFICATIONS
General Specifications
|
XJ650G |
Basic color Dimensions: Overall length |
8. A.C. Generator
a. Install the rotor onto the shaft and
tighten the bolt using the rotor holding
tool (special tool) as shown.
1. Rotor holding tool
Tightening torque: 5.5 m-kg (39.8 ft-lb)
12. Cylinder head and Cam shafts
a. Install the new cylinder head gasket. Install the dowel pins and "O-rings". Locate the cam chain cavity cylinder seal with the tabs down.
b. Install the cylinder head onto the cylinder. Pull the cam chain through the cylinder head as it is installed. Tie the cam chain so that it does not fall into the crankcase.
FRONT FORK
A. Removal and Disassembly
WARNING:
Securely support the motorcycle so there is no danger of it falling over.
ENGINE
A. Valve Clearance Adjustment
NOTE:-
Valve clearance must be measured with the engine and at room temperature.
1. Remove the seat and fuel tank.
2. Remove the horn, flasher relay, and spark plug lead wires.
P. Middle Gear
1. Damper disassembly
NOTE:-------------------------------------------------------
Disassembly of the middle gear damper requires the damper compressor (special tool) and a hydraulic press.
a. Place the middle drive shaft in a press with the damper compressor (special tool) in place as shown.
HTML clipboard
CABLE ROUTING
SHAFT DRIVE
Refer to "CHAPTER 3". for the middle gear.
The following special tools are not available but can be constructed for the final gear
disassembly and assembly: