650H (Maxim)

ELECTRIC STARTING SYSTEM

A. Circuit Diagram

Above circuit diagram shows starter circuit in wiring diagram.

B. Starter Motor

1.    Removal (see CHAPTER 3. "ENGINE DISASSEMBLY")

2.    Inspection and repair

XJ650G WIRING DIAGRAM

CHAPTER 4. CARBURETION

CARBURETOR

A. Section View

B. Specifications

ELECTRICAL

A. Battery

1. The fluid level should be between the upper and lower level marks. Use only distilled water if refilling is necessary.

CAUTION:
Normal tap water contains minerals which are harmful to a battery; therefore, refill only with distilled water.

CHASSIS

A. Fuel Petcock

If the fuel petcock is leaking or excessively contaminated, it should be removed from the fuel tank and inspected.

1.    Remove the fuel tank and position it so that fuel will not spill when the petcock is removed.

ENGINE

A. Valve Clearance Adjustment

NOTE:
Valve clearance must be measured with the engine and at room temperature.

1.    Remove the seat and fuel tank.

2.    Remove the horn, flasher relay, and spark plug lead wires.

CHAPTER 2. PERIODIC INSPECTIONS AND ADJUSTMENTS

INTRODUCTION

YAMAHA

XJ650G and XJ650H (Maxim)

Note:
A separate manual covers the European and Austrailian versions of this model.

NOTICE

TABLE OF CONTENTS:

C. Middle Gear Servicing

1.    Disassembly

Refer to page 39 for disassembly.

2.    Inspection

Refer to page 52 for inspection.

3.    Gear lash check

NOTE:
The middle gear lash can be checked only when the gears are installed in the crankcase.