550J (Maxim)

CONSUMER INFORMATION

Notice The information presented represents results obtainable by skilled drivers under controlled road and vehicle conditions, and the information may not be correct under other conditions.

STOPPING DISTANCE

A.  Removal

1. Remove one (1) rear shock absorber at at time, inspect and reinstall before removing the other.

B.    Inspection

1.    Check the rod. If it is bent or damaged, replace the shock absorber.

2.    Check for oil leakage. If oil leakage is evident, replace the shock absorber.

CHARGING SYSTEM

B. A.C. generator

1. Checking method.

a.   Connect D.C. voltmeter to the battery terminals.

b.  Start engine.

c.   Accelerate engine to approximately 2,000 r/min or more and check generated voltage.

Generated voltage: 14.5 ± 0.3V

A. Cable maintenance

NOTE:
See Maintenance and Lubrication intervals charts. Cable maintenance is primarily concerned with preventing deterioration through rust and weathering and providing proper lubrication to allow the cable to move freely within its housing. Cable removal is straight forward and uncomplicated. Removal will not be discussed within this section.

Carburetion

STEERING HEAD

A.   Adjustment

Refer to "D. Reassembly" for steering head adjustment procedure.

B.   Removal

1. Remove the cowling assembly, meters, horn, front wheel, front forks, handlebar cover and handlebars.

A. Removal and disassembly

WARNING:
Securely support the motorcycle so there is no danger of it falling over.

1.    Remove the cowling assembly.