1. Measure fuel level. Adjust if out of specification.
Measurement steps:
• Place the motorcycle on a level surface.
• Shim the center stand as required to level from side to side using a level across the carb bank
LIGHTING SYSTEM
CABLE MAINTENANCE
NOTE:
See "Maintanance and Lubrication" intervals charts. Cable maintenance is primarily concerned with preventing deterioration and providing proper lubrication to allow the cable to move freely within its housing. Cable removal is straightforward and uncomplicated. Removal is not discussed within this section.
Chassis
|
Steering System: Steering Bearing Type |
Taper Roller Bearing |
Front Suspension: |
REMOVAL AND DISASSEMBLY
1. Drain coolant
2. Remove horns 1
3. Disconnect electrical leads 2
MIDDLE GEAR SERVICE
1 Spring retainers
2 Spring seat
3 Damper cams
4 Midde drive gear shim
5 Bearing
6 Bearing retainer
7 Middle drive shaft
8 Middle driven shaft
9 Shim
10 O-ring
11 Bearing housing
12 Oil seal (35 x 5 0x6)
SHAFT DRIVE
Refer to "CHAPTER 3". for the middle gear.
The following special tools are not available but can be constructed for the final gear disassembly and assembly:
SWITCHES
Use Pocket Tester (90890-03112) on "Ohm x 1" scale to check the switches. Replace any "shorted" or opened element.
Main Switch
|
Switch position |
