Important information
1. All gaskets and seals should be replaced when an engine is overhauled. All gasket surfaces and oil seal lips must be cleaned.
2. Properly oil all mating engine and transmission parts and bearings during reassembly.
FRONT WHEEL
Removal
1. Place the motorcycle on the center stand.
2. Remove the speedometer cable from the speedometer.
3. Remove the front fender securing bolts and remove the fender.
XJ900RK CIRCUIT DIAGRAM Models Without Side Stand Switch
| 1. | A. C. |
CYLINDER HEAD
VALVE
CAM CHAIN
CAUTION: Disc brake components rarely require disassembly. Do not disassemble components unless absolutely necessary. If any hydraulic connection in the system is opened, the entire system should be disassembled, drained, cleaned and then properly filled and bled upon reassembly. Do not use solvents on brake internal components. Solvents will cause seals to swell and distort. Use only clean brake fluid for cleaning. Use care with brake fluid.
FINAL GEAR/DRIVE SHAFT
A. ENGINE
Cylinder head:
Volume 24,5 ±0.4 cm3 (1.49 ± 0.0244 cu.in)
Warp limit < 0.03 mm (0.0012 in)
* Lines indicate straightedge measurement
Cylinder:
