HEADLIGHT
Headlight Bulb Replacement
1. Remove securing screws (1) from light unit assembly/headlight body.
2. Disconnect the headlight lens unit leads
3. Remove the light unit assembly
4. Rotate the bulb holder (1) counterclockwise.
5. Remove the defective bulb
6. Install new bulb and secure with bulb holder.
CAUTION:
• Avoid touching glass part of bulb.
• Keep the bulb free from oil otherwise, transparency of glass, bulb life, and luminous flux will be adversely affected.
• If oil gets on bulb, clean it with a cloth moistened thoroughly with alcohol or lacquer thinner.
WARNING:
Do not touch the headlight bulb when it is on, as the bulb generates enormous heat; keep flammable objects away.
7. Install the light unit assembly to headlight body.
Headlight Beam Adjustment Horizontal adjustment:
1. Rotate the horizontal adjusting screw (1)
|
Horizontal Adjustment of Headlight Beam |
|
|
Adjusting screw |
Beam direction |
|
Turn clockwise |
> to Right |
|
Turn counterclockwise |
<- to Left |
|
Horizontal Adjustment of Headlight Beam |
|
|
Adjusting screw |
Beam direction |
|
Turn clockwise |
> to Right |
|
Turn counterclockwise |
< to Left |
Vertical adjustment: 1. Rotate:
• Vertical adjusting screw (2)
|
Vertical Adjustment of Headlight Beam |
|
|
Adjusting screw |
Beam direction |
|
Turn clockwise |
to Raise |
|
Turn counterclockwise |
to Lower |
FUSE
The fuse box is under the indicator light panel. The main fuse is under the seat.
(1) Main fuse
(2) Spare fuses
(3) Other fuse block
Blown fuse procedure steps:
• Turn off ignition and the circuit.
• Install a new fuse of proper amperage.
• Turn on switches to verify operation of electrical device.
• If fuse blows immediately again, check circuit in question.
WARNING:
Do not use fuses of higher amperage rating than recommended. Extensive electrical system damage and fire could result from substitution of a fuse of improper amperage.
- Printer-friendly version
- Log in to post comments