Maintenance Specifications -- Electrical
Electrical
Voltage: 12V |
Ignition System: |
- Read more about Maintenance Specifications -- Electrical
- Log in to post comments
Electrical
Voltage: 12V |
Ignition System: |
REMOVAL
1. Drain coolant
2. Remove radiator assembly
Refer to CHAPTER 3 "ENGINE REMOVAL".
INSPECTION
FRONT WHEEL
1 Wheel axle
2 Collar
3 Oil seal
4 Bearing
5 Spacer
6 Speedometer gear unit
7 Tire
COOLING SYSTEM
3 Main switch
4 Fuse "FAN" (10A)
5 Thermo switch
6 Fan motor
18 Temperature meter
19 Thermo unit
35 Fuse "SIGNAL" (15A)
48 Battery
49 Fuse "MAIN" (30A)
LUBRICATION DIAGRAM
FRONT BRAKE
REMOVAL
1. Remove carburetor assembly. Refer to engine removal section.
NOTE: The following parts can be cleaned and inspected without disassembly.
• Piston valve
• Jet needle
2. Disconnect:
INSTALLATION
1. Install carburetors: Reverse the removal steps.
Yeah, right...
Maxim X Carburetor Installation
A Technique for reinstalling old hardened intake boots. (Note: This will probably not work on other models with long boots)
This is not a Yamaha procedure. It was developed by Joe D. HAP and dv
NOTE: It is not necessary to remove the engine in order to remove the following components:
• Piston
• Clutch
• Carburetor
• Oil pump
• Water pump