750K (Maxim)

Cleaning the Hitachi Carb

This series assumes you took the carbs apart, and are trying to figure out how to put them back together again. If you haven’t taken them apart yet, it’s a good idea to skim through this first anyway. Address any questions to: xj-owners@micapeak.com, and we’ll try to talk you through it.

 

Pictures and text by Dwayne Verhey

Tags:

Specifications

SPECIFICATIONS

GENERAL SPECIFICATIONS

Item

XJ750K

Dimensions:

Overall Length

Battery

E. Battery

1. Checking

If the battery shows the following defects, it should be replaced.

a.   The battery voltage will not rise to a specific value or no gassing occurs in any cell even after many hours of charging.

b.  Sulfation of one or more cells is indicated by the plates turning white or an accumulation of material in the bottom of the cell.

Switches

 

D. Switches

Switches may be checked for continuity with a pocket tester on the "ohm x 1" position.

1. Main switch

Switch Poiition

Wire Color

R

Br

Front Brake Caliper and Master Cylinder

1. Remove the caliper brake hose. Allow fluid in the caliper assembly to drain into a container.

2.    Place the open hose end into the container and pump the old fluid out carefully.

3.    Remove the caliper mounting bolt and the pad retaining bolt.

4.    Remove the caliper assembly from the caliper frame.

5.    Remove the dust seal.

Front Fork, Rear Shock

Front fork and rear shock absorber adjustment

Front fork air pressure

1. Elevate the front wheel by placing the motorcycle on the center stand.

NOTE:

Final Gear / Driveshaft

FINAL GEAR / DRIVE SHAFT

Clutch

CLUTCH

Adjustable Footrest

ADJUSTABLE FOOTREST

Recommended lubricants: Yamaha chain and cable lube or SAE10W30 motor oil

Middle Gear Damper

MIDDLE GEAR/DAMPER