Engine Oil

 

At 5°C (40°F) or Higher:
SAE 20W40 Type SE Motor Oil 

At 15°C (60°F) or Lower:
SAE 10W30 Type SE Motor Oil

NOTE:
Recommended engine oil classification; API Service "SE", "SF" type or equivalent (e.g. "SF-SE", "SF-SE-CC", "SF-SE-SD" etc.)

Oil Level Measurement

1. Check
• Oil level

Oil level low — Add sufficient oil.

Oil level visual inspection steps:
• Place the motorcycle on its center stand and warm up the engine for several minutes.

NOTE:
Position the motorcycle straight up when checking oil level, a slight tilt to the side can produce false readings.

• Stop the engine and visually check the oil level through the level window (1).

(2) Maximum (3) Minimum

Oil Change (Without filter)

1.      Warm up the engine for several minutes, then place a receptacle under the engine.

2.      Remove:
•   Oil filler cap

3.      Remove:
•   Engine drain plug (1)

4.     Tighten:
•   Drain plug

Engine Drain Plug:
43 Nm (4.3 m-kg, 31 ft-lb)

5. Fill:
• Crankcase

Engine Oil
2.5 L (2.2 imp qt, 2.6 US qt)

CAUTION:

Do not allow foreign material to enter the crankcase.

6. Install:
•   Filler cap

Oil Change (With filter)

1.      Warm up the engine and place a receptacle under the engine.

2.      Remove:
•   Oil filler cap
•   Drain plug

Drain the engine oil.

3.      Remove:
•  Oil filter bolt (1)
•  Filter cover (2)

4.      Tighten:

•  Drain plug

Engine Drain Plug:

43 Nm (4.3 m-kg, 31 ft-lb)

5. Install:
•  Oil filter bolt (1)
•  Spring (2)
•  Washer (3)
•  Oil filter (New) (4)
•  O-ring (5)
•  Oil filter assembly

•   Be sure the O-ring (5) is positioned properly.

•   Fit the filter cover projection into the crank-case cover slot.

6. Tighten:
• Oil filter bolt

Oil Filter Bolt:
15 Nm (1.5 mkg, 11 ftlb)

7. Fill:

• Crankcase

Engine Oil:
2.8 L (2,5 imp qt, 3.0 US qt)

8.      Install:
•  Oil filler cap

9.     Warm up the engine and check for oil leaks. Stop the engine instantly if leaking occurs.

Leaks — Check cause.

10.   Check:
•  Oil level

Level low — Add sufficient oil.